The two grooves are easier to clean and parts for both are readily available. I would like to replace the stock/wood on one.to make it look ''like new'' for re-enactments and keep the original stock for Provenance etc.Problem is there are so many Indian un-issued wood sets around and the Canadian ones are like rocking horse sh*T
Both have walnut stocks / wood and one has a matched bolt.sadly the one I got from franks doesn'tīoth stripped and cleaned and 1 to 2 inch groupings at 100yds after 20 minutes fettling. Sent you a PM about the/my '42 Savage in your. '49 LB Mk.1 SN 91L0865, Mk.III backsight and Mk.III slide. III yellow-nosed cadet, SN D over 46133 w/matching nose-cap, scrubbed bolt. this was also an un-fired example but looked like it had been used for drill as the butt plate was a bit battered. Rifle, Short, Magazine Lee Enfield Mark 3 - 1907, different sights The SMLE Mk III, 26 January 1907, featured a simplified rear sight arrangement and a fixed charger guide, and was chambered to fire the Mk VII High Velocity spitzer. III, w/DD, renumbered SN G over 80429, matching bolt/rcvr, no nose-cap number. I have a couple of 5 groove no 4's ( both Long branch / Canadian Arsenal ) one of which I brought back personally from Italy 5 years ago - still in a wooden case ,wrapped in grease proof paper and cosmoline.A real find !! I had several 'two thoughts'' whether or not to use it - but the royal armouries have plenty in cases that people just look at and in the end rifles are meant to be used.The other I got from Henry Kranks in Leeds. It has another symbol that im not sure of: A broad arrow over what seem to be an 8.
Mark 3 enfield serial number look up serial numbers#
The bolt head seem to a Reissued one it has a small 's' and Ishapore cross pennants mark over the old serial marking i think. Lee Enfield No4 Mk2 Serial Numbers Rating: 3,6/5 832 votes 11111111111111111111 No4 rifles were given a starting number that may be used to identify manufacturers, but again there was no set serial blocks. The basis was '' its needs to kill, not bothered about what it looks like '' It also have a 'O' and '34' marking on the top of the collar and I dont know what it mean. The 2 groove barrelled were manufactured to speed up the process.They ''slimmed'' down the manufacturing process.
0 kommentar(er)
